Not sure which system is right for you?
Check our Consumer Guide for brand recommendations or search your local water quality report first.
A deep dive into the science behind every major water filtration and purification method.
Check our Consumer Guide for brand recommendations or search your local water quality report first.
Water passes through a physical barrier (mesh, ceramic, or wound fiber) that traps particles by size. Measured in microns — the lower the micron rating, the finer the filtration.
Best For
Pre-treatment before other filtration stages; well water with visible particles
Limitations
Does not remove dissolved chemicals, heavy metals, or bacteria. Filters require regular replacement as they clog.
Activated carbon has an enormous surface area covered in microscopic pores. Contaminants adsorb (stick) to this surface as water flows through. Carbon block is denser and more effective than granular (GAC).
Best For
Chlorine, THMs, HAAs, taste & odour, some VOCs and pesticides
Limitations
Has limited capacity — must be replaced regularly. Does not remove nitrates, fluoride, or heavy metals (unless specially certified).
Pressurized water is forced through a semi-permeable membrane with pores ~0.0001 microns. Only water molecules pass through — dissolved ions, metals, and most contaminants are rejected and flushed to drain.
Best For
Drinking water treatment — lead, PFAS, arsenic, nitrates, fluoride, chromium-6
Limitations
Wastes 3–4 gallons of water per gallon produced. Slow flow rate. Removes beneficial minerals. Storage tank required.
Water flows through resin beads that exchange harmful ions for harmless ones. Water softeners swap calcium/magnesium for sodium. De-ionization resins swap all ions for hydrogen and hydroxide (producing pure water).
Best For
Water softening, nitrate removal, some heavy metals
Limitations
Softeners add sodium (concern for low-sodium diets). Resin must be regenerated with salt or acid. Does not remove PFAS, bacteria, or organic compounds.
Water passes by a UV-C lamp (254 nm wavelength). UV radiation penetrates microorganism cells and disrupts their DNA, preventing reproduction. No chemicals are added.
Best For
Well water disinfection, killing bacteria, viruses, Giardia, and Cryptosporidium
Limitations
Has NO residual effect — bacteria can regrow after treatment. Requires pre-treatment for turbid water. Lamp requires annual replacement. Does not remove chemical contaminants.
Water is boiled into steam, leaving contaminants behind. The steam is then condensed back into liquid in a separate chamber. One of the most thorough purification methods.
Best For
Laboratory-grade purity; areas with highly contaminated well water
Limitations
Very slow (1 gallon per several hours). High energy consumption. Removes all minerals. Expensive to operate. VOCs can carry over with steam if no carbon post-filter.